UMN:CLI
User Manual
V5824G
552
To specify the protocol on the current VoIP service, use the following command.
Command
Mode
Description
protocol
{
h248
|
sip
|
mgcp
}
Traffic
VoIP-IP-
path
Specifies the protocol on the current VoIP service.
sip: Session Initiation Protocol
h248, mgcp: Media Gateway Control protocol
(= MEGACO)
11.4.6.4
POTS UNI Configuration
To configure the user network interface, use the following command.
Command
Mode
Description
uni
{
pots
|
isdn
}
POTS_NUMBER
Traffic-VoIP
Configures the VoIP user network interface.
pots: POTS (Plain Old Telephone Service)
isdn: ISDN (Integrated Services Digital Network) (future
release)
POTS_NUMBER: POTS port number
no
uni
{
pots
|
isdn
}
POTS_NUMBER
Deletes the configuration of UNI.
If you specify UNI as the POTS by using
uni pots
command, you need to perform the
configuration for the interface in
VoIP-UNI Configuration
mode as follows:
When you use the
uni pots
command, you enter automatically
VoIP-UNI Configuration
mode, where you can configure the specified POTS interface.
To specify the impedance for the POTS UNI, use the following command.
Command
Mode
Description
impedance
{
600
|
900
|
750
|
820
|
1050
}
Traffic
VoIP-UNI
Specifies the impedance for the specified POTS UNI.
600: 600 Ohm (default)
900: 900 Ohm
750: C1=150 nF, R1=750 Ohm, R2=270 Ohm
820: C1=115 nF, R1=820 Ohm, R2=220 Ohm
1050: C1=230 nF, R1=1050 Ohm, R2=320 Ohm
no impedance
Deletes the configured impedance for the POTS UNI.
i
