User Manual
UMN:CLI
V5824G
595
misconnect-packet-declaration-
policy
<1-100>
malformed-packet: malformed packet
misconnect-packet: misconnect packet
1-100: anomaly rate (unit: integer percentage)
buffer-over-underrun-clear-
policy
<0-99>
Defines
the
anomaly
rate
that
causes
the
corresponding alarm to be cleared. If no more than this
density of anomalies occurs during the alarm clear
soak interval, the alarm is cleared.
buffer-over-underrun: buffer overrun/underrun
loss-packet: loss packet
malformed-packet: malformed packet
misconnect-packet: misconnect packet
1-99: anomaly rate (unit: integer percentage)
loss-packet-clear-policy
<0-99>
malformed-packet-clear-policy
<0-99>
misconnect-packet-clear-policy
<0-99>
To delete the configured anomaly rate, use the following command.
Command
Mode
Description
no buffer-over-underrun-declaration-policy
PW-
Maintenance-
Profile
Deletes the configured anomaly rate
that causes the corresponding alarm
to be declared or cleared.
no loss-packet-declaration-policy
no malformed-packet-declaration-policy
no misconnect-packet-declaration-policy
no buffer-over-underrun-clear-policy
no loss-packet-clear-policy
no malformed-packet-clear-policy
no misconnect-packet-clear-policy
11.9.6
L-bit/R-bit Receive/Transmit Policy
To configure the L-bit receive policy, use the following command.
Command
Mode
Description
l-bit-receive-policy
{
play-out
|
repeat-last-packet
|
send-idle
}
PW-
Maintenance-
Profile
Defines the action toward the TDM interface when far
end TDM failure is indicated on packets received from
the PSN (L-bit set).
play-out: Play out service-specific AIS (default)
repeat-last-packet: Repeat last received packet
send-idle: Send channel idle signalling and idle
channel payload to all DS0s comprising the service
no l-bit-receive-policy
Deletes the configured L-bit receive policy.
