UMN:CLI
User Manual
V5824G
36
3.1.1
Privileged EXEC View Mode
When you log in to the switch, the CLI will start with
Privileged EXEC View
mode which is
a read-only mode. In this mode, you can see a system configuration and information with
several commands.
Privileged EXEC View
mode.
Command
Description
enable
Opens
Privileged EXEC Enable
mode.
exit
Logs out the switch.
show
Shows a system configuration and information.
Tab. 3.1
Main Command of
Privileged EXEC View
Mode
3.1.2
Privileged EXEC Enable Mode
To configure the switch, you need to open
Privileged EXEC Enable
mode with the
enable
command, then the system prompt will changes from SWITCH> to SWITCH#.
Command
Mode
Description
enable
View
Opens
Privileged EXEC Enable
mode.
You can set a password to
Privileged EXEC Enable
mode to enhance security. Once
setting a password, you should enter a configured password, when you open
Privileged
EXEC Enable
mode.
Privileged EXEC Enable
mode.
Command
Description
clock
Sets a system time and date.
configure terminal
Opens
Global Configuration
mode.
reload
Reboots the system.
telnet
Connects to a remote host through telnet.
terminal length
Configures the number of lines of the current terminal.
traceroute
Traces a packet route.
where
Displays users accessing the system via telnet or console.
Tab. 3.2
Main Command of
Privileged EXEC Enable
Mode
