User Manual
UMN:CLI
V5824G
41
RMON Configuration
mode.
Command
Description
active
Activates RMON.
owner
Shows the subject which configures each RMON and uses relevant
information.
Tab. 3.10
Main Command of
RMON Configuration
Mode
3.1.11
Router Configuration Mode
In
Router Configuration
mode, you can configure IP routing protocols and VRRP. The
V5824G provides three IP routing protocols such as RIP v2, BGP v4 and OSPF v2.
To open
Rule Configuration
mode, enter the
router
command, then the system prompt
will be changed from SWITCH(config)# to SWITCH(config-router)#.
Command
Mode
Description
router
{
IP-PROTOCOL
|
vrrp
}
Global
Opens
Router Configuration
mode to configure IP
routing protocols and VRRP.
Router Configuration
mode.
Command
Description
distance
Configures distance value to find better route.
neighbor
Configures neighbor router.
network
Configures network to operate each routing protocol.
redistribute
Registers transmitted routing information to another router’s table.
associate
Configures associated IP address same with virtual router.
authentication
Configures password of virtual router group.
preempt
Activates/deactivates preempt.
vr-priority
Assigns priority to virtual router.
vr-timers
Configures advertisement time, which means the interval that master
router distributes its information to another virtual router.
Tab. 3.11
Main Command of
Router Configuration
Mode
3.1.12
Route-Map Configuration Mode
In
Route-map Configuration
mode, you can configure to transmit routing information with
various options.
To open
Route-map Configuration
mode, enter the
route-map
command, then the
system prompt will be changed from SWITCH(config)# to SWITCH(config-route-map)#.
Command
Mode
Description
route-map
NAME
{
permit
|
deny
}
<1-65535>
Global
Opens
Route-map Configuration
mode
.
