User Manual
UMN:CLI
V5824G
481
11.1.15
Multicast/Broadcast GEM Port Separation
All the downstream multicast and broadcast flows from the V5824G are transmitted
through a single GEM port ID. The multicast and broadcast flows need to be separated
from each other to properly forward all broadcast/multicast traffic for multiple ONTs.
To configure a multicast GEM port ID, use the following command.
Command
Mode
Description
olt multicast-gem
<4094-4095>
GPON
Adds a specific GEM port ID to the multicast stream.
4094-4095: multicast GEM port ID
show olt multicast-gem
GPON
GPON-OLT
Shows the specified GEM port ID for multicast stream.
To enable/disable the interworking with IGMP snooping table, use the following command.
Command
Mode
Description
olt
interwork
igmp-snooping
{
enable
|
disable
}
GPON
Enables/disables the interworking with IGMP snooping
table.
To add a static MAC address into the MAC table, use the following command.
Command
Mode
Description
olt static-mac
MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
GPON-OLT
Adds a static MAC address for multicast/broadcast
stream.
olt static-mac start
MACADDR
end
MACADDR
{
mcast
|
bcast
}
[
vid
<1-4094>]
Adds a static range of MAC addresses for
multicast/broadcast stream.
no olt static-mac
MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
Deletes the configured static MAC address.
no
olt
static-mac
start
MACADDR
end
MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
Deletes the configured static MAC address range.
To display the configured static MAC address table, use the following command.
Command
Mode
Description
show olt static-mac
GPON-OLT
Shows the static MAC table.
