UMN:CLI
User Manual
V8102
182
7.6.3
EFM OAM Mode
To configure EFM OAM mode, use the following command.
Command
Mode
Description
oam efm mode
{
active
|
passive
}
PORTS
Global
Configures the mode of EFM OAM.
Both request and loopback can be available in the EFM OAM active mode. However, re-
quest or loopback is not available in the OAM passive mode.
7.6.4
OAM Loopback
For OAM loopback function, both the switch and the host should support OAM function.
OAM l
oopback function enables Loopback function from the user’s device to the host
which connected
to the user’s device and operates it.
To enable/disable the remote loopback mode, use the following command.
Command
Mode
Description
oam efm remote-loopback
permit
PORTS
Global
Receives the loopback control commands from its
remote peer switch.
oam efm remote-loopback
deny
PORTS
Ignores the loopback control commands from its re-
mote peer switch. (Default)
To configure loopback function of the host connected to the switch, use the following
command.
Command
Mode
Description
oam efm remote-loopback
enable
PORTS
Global
Enables loopback function of peer device.
oam efm remote-loopback
disable
PORTS
Disables loopback function of peer device.
oam efm remote-loopback test
<1-100>
PORTS
Starts to perform the test of loopback operation.
1-100: the number of test packets
7.6.5
OAM Unidirection
When RX is impossible in OAM, it is possible to send the information by using TX. To en-
able/disable the function, use the following command.
Command
Mode
Description
oam efm unidir enable
PORTS
Global
Sends the information by using TX.
oam efm unidir disable
PORTS
Disables to transmit the information by using TX.
i