User Manual
UMN:CLI
V8102
265
This setting is only possible when corresponding Receiver exists.
To set or delete Receiver’s index, use the following command.
Command
Mode
Description
sflow receiver-index
<1-65535>
Interface
[GPON]
Sets Receiver;s index in a range of <1-65535>.
no sflow receiver-index
Deletes
Receiver’s index and restores default value.
(default value: 0)
The port cannot send sflow packet to Collector if the Receiver’s index value is in default
value.
7.19.1.7
Displaying sFlow Setting
To display current service status, agent IP, sflow setting for each port and Receiver, use
the following command.
Command
Mode
Description
show sflow
Enable
Global
Shows sflow information.
7.19.2
sFlow Receiver Setting
7.19.2.1
sFlow Receiver Setting
With the following command, user can create Receiver including index and enter Receiv-
er mode. Receiver value cannot be set in Receiver Mode.
If the corresponding Receiver exists, user can enter the Receiver Mode.
To enter Receiver Mode to set sFlow Receiver, use the following command.
Command
Mode
Description
sflow-receiver
<1-65535>
Global
Enters Receiver mode by creating Receiver including
specified index and sets Receiver value. If the corre-
sponding Receiver exists, you can enter the Receiver
Mode.
no sflow-receiver
<1-65535>
Deletes Receiver if the corresponding Receiver with
the specific index exists.
i
i
i