UMN:CLI
User Manual
V8102
266
7.19.2.2
Collect-IP Address and Port Setting
To set or delete Receiver’s Collect-IP address, use the following command.
Command
Mode
Description
collect-ip ip-address
Receiver
Sets Recever’s Collect-IP address.
no collect-ip
Deletes Receiver’s Collect-IP address and restores
default value. (default value: 0.0.0.0)
If Receiver’s Collect-IP is default value (0.0.0.0), the sflow packet that uses this Receiver
cannot be sent to Collector.
To set or delete the Collect-port of corresponding Receiver, use the following command.
Command
Mode
Description
collect-port
<1-65535>
Receiver
Sets Collect port of corresponding Receiver.
no collect-port
Deletes Receiver’s Collect port and restores default
value. (default value: 6343)
7.19.2.3
Datagram Size
Datagram refers to a packet which has sufficient information for routing between source
data terminal and destination data terminal, not through the pre-connection procedure be-
tween the data terminal device and network. This device can set the size of datagram
packets. To set or delete Receiver’s Collect port, use the following command.
Command
Mode
Description
max-datagram-size
<256-1400>
Receiver
Sets the miximum size of datagram that sampled pack-
et to be sent using the corresponding Receiver.
no max-datagram-size
Deletes the maximum size of datagram and restores
default value. (default value: 1400)
7.19.2.4
User Name
This device can set owner name to indicate who is using Receiver with the following
command.
Command
Mode
Description
owner receiver-name
Receiver
Sets Owner name of Receiver.
no owner
Deletes Owner name of Receiver.
If owner name is deleted, the corresponding Receiver’s Collect IP address, port, data-
gram size, timeout value and others restore default value.
i
!
