User Manual
UMN:CLI
V8102
685
auto-cost
reference-bandwidth
<1-4294967>
Router
Sets the reference bandwidth for the cost on interface.
1-4294967: reference bandwidth value (default:
100Mbps)
To restore the reference bandwidth to its default value and thus restore the default costs
of interface to their default value, use the following command.
Command
Mode
Description
no
auto-cost
reference-
bandwidth
Router
Restores the reference bandwidth to its default value.
12.3.5
Non-Broadcast Network
To operate NBMA type network, neighbor router configuration is needed. And IP address,
Priority, Poll-interval configuration as well. Priority is information for designate router se-
lection and it configured [0] as a default. Poll-interval is the waiting time to re-get the hello
packet from dead Neighbor router. It configured 120 seconds as a default.
To configure a router communicated by non-broadcast type, use the following command.
Command
Mode
Description
ipv6 ospf neighbor
X:X::X:X
[
instance-id
<0-
255>]
Interface
[VLAN]
Configures a neighbor router of NBMA
type.
X:X::X:X: neighbor IPv6 address
To delete a configured router communicated by non-broadcast type, use the following
command.
Command
Mode
Description
no ipv6 ospf neighbor
X:X::X:X
[
instance-id
<0-
255>]
Interface
[VLAN]
Deletes a configured neighbor router of
NBMA type.
12.3.6
OSPFv3 Area
Router configuration on OSPFv3 network includes Area configuration with each interface,
network. This area has various and special features. It needs to be configured pertinently
to make effective management on whole of OSPFv3 network.
OSPFv3 network defines several router types to manage the Area. ABR (Area Border
Router) is one of the router types to transmit information between Areas.
ASBR (Autonomous System Border Router) is using OSPFv3 on one side and using oth-
er routing protocol except for OSPFv3 on other interface or Area. ASBR exchanges area
information between different routing protocols.
