User Manual
UMN:CLI
V8102
745
13.1.11.6
DB Synchronization
To display the synchronization status of the active OLT and standby OLT DB, use the fol-
lowing command.
Command
Mode
Description
olt redundancy db-sync check
group GROUP-ID
Global
Shows the synchronization status of the active OLT
and standby OLT DB.
GROUP-ID: redundancy group ID
To resynchronize the active OLT and standby OLT DB, use the following command.
Command
Mode
Description
olt redundancy db-sync resync
group GROUP-ID
Global
Resynchronizes the active OLT and standby OLT DB.
(This is executed only when two DBs are different each
other.)
GROUP-ID: redundancy group ID
13.1.11.7
Displaying Redundancy Information
To display the OLT redundancy configuration, use the following command.
Command
Mode
Description
show olt redundancy status
Enable
Global
Interface
[GPON]
Shows the role of each OLT and the reason for
switchover.
show olt redundancy detail-
status
[
GROUP-ID
]
Shows all of the detail information on all or specified
redundancy group(s).
GROUP-ID: redundancy group ID
You can check the status of RX power by using
show olt redundancy detail-status
command that shows the status information as "RX Detect".
13.1.12
Maximum Number of ONU
You can set the maximum number of ONUs (ONTs) connected to a specified OLT. To set
the maximum number of ONUs, use the following command.
Command
Mode
Description
olt max-onu-count
<1-128>
Interface
[GPON]
Sets the maximum number of ONU connections.
1-128: maximum number of ONUs connected to a
specified OLT (default: 128)
no olt max-onu-count
Removes the maximum number of ONU.
i