User Manual
UMN:CLI
V8102
751
13.1.17
Multicast/Broadcast GEM Port Separation
All the downstream multicast and broadcast flows from the V8102 are transmitted through
a single GEM port ID. The multicast and broadcast flows need to be separated from each
other to properly forward all broadcast/multicast traffic for multiple ONTs.
To configure a multicast GEM port ID, use the following command.
Command
Mode
Description
olt multicast-gem
<4094-4095>
Global
Adds a specific GEM port ID to the multicast stream.
4094-4095: multicast GEM port ID
show olt multicast-gem
Enable
Global
Interface
[GPON]
Shows the specified GEM port ID for multicast stream.
To enable/disable the interworking with IGMP snooping table, use the following command.
Command
Mode
Description
olt
interwork
igmp-snooping
{
enable
|
disable
}
Global
Enables/disables the interworking with IGMP snooping
table.
To add a static MAC address into the MAC table, use the following command.
Command
Mode
Description
olt static-mac MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
Interface
[GPON]
Adds a static MAC address for multicast/broadcast
stream.
olt static-mac start MACADDR
end MACADDR
{
mcast
|
bcast
}
[
vid
<1-4094>]
Adds a static range of MAC addresses for mul-
ticast/broadcast stream.
no olt static-mac MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
Deletes the configured static MAC address.
no olt static-mac start MAC-
ADDR
end MACADDR
{
mcast
|
bcast
} [
vid
<1-4094>]
Deletes the configured static MAC address range.
To display the configured static MAC address table, use the following command.
Command
Mode
Description
show olt static-mac gpon
OLT-ID
Enabl/Global
Shows the static MAC table.
show olt static-mac
Interface
[GPON]