UMN:CLI
User Manual
V8102
762
Serial Number-based ONU Registration
For ONU (ONT) registration, OLT requests a serial number of the connected ONUs
(ONTs) periodically. OLT registers a specific ONU which replies to OLT with its serial
number. The V8102 can allocate ONU-ID to an ONU which sends a valid serial number to
OLT. When ONU with the specific serial number is activated, it is assigned the allocated
ONU-ID.
To register/delete ONU (ONT) automatically by ONU
’s serial number acquisition, use the
following command.
Command
Mode
Description
discover-serial-number start
<1-1200>
Interface
[GPON]
Starts to register ONT by its serial number and
specifies an interval for ONU
’s serial number
acquisition.
1-1200: serial number acquisition interval
discover-serial-number stop
Stops discovering ONT using its serial number.
show discover-serial-number
interval
Shows the configured interval for requesting
ONU
’s serial number.
show discover-serial-number
interval
[
gpon OLT-ID
]
Enable/Global
To remove the serial number of ONU, use the following command.
Command
Mode
Description
onu remove serial-number ONU-
ID
Interface
[GPON]
Removes the ONU serial number.
ONU-ID: ONU ID (1-128) or ONU serial number
Registration ID-based ONU Registration
A registration ID is assigned to a subscriber at the management level, and provisioned
both into the OLT and communicated to installation or repair personnel or even to the
subscriber directly. The registration ID populates the ONU
’s PLOAM password, which is
used by the OLT to recognize the ONU. The OLT may learn the value of the ONU
’s serial
number for possible subsequent use in serial number based authentication.
To enter the registration ID into the ONU in the field, use the following command.
Command
Mode
Description
onu add ONU-ID registration-id
ID
Interface
[GPON]
Adds ONU (ONT) with a specified resgistration ID.
ID: registration ID (PLOAM password)