User Manual
UMN:CLI
V8102
785
as follows:
To display the status of ONU firmware, use the following command.
Command
Mode
Description
show onu firmware version
gpon
OLT-ID
[
ONU-IDs
]
Enable
Global
Shows the status of ONU firmware.
OLT-ID: GPON port number
ONU-ID: ONU ID (1-128) or ONU serial number
show onu firmware version
[
ONU-IDs
]
Interface
[GPON]
Shows the status of ONU firmware.
ONU-ID: ONU ID (1-128) or ONU serial number
(3) Specifying Default OS of ONU
To specify the default OS of ONU (ONT), use the following command.
Command
Mode
Description
onu firmware commit ONU-ID
{
os1
|
os2
}
Interface
[GPON]
Specifies the default OS of ONU (ONT).
(4) Restarting ONU
In order to use the new upgraded firmware, you should restart the ONU (ONT). At this
time, the upgraded OS should be specified as a default OS by using
onu firmware
commit
command.
Before restarting the ONU (ONT), you should check the service status of ONU, whether
to save the other configuration, or else.
To restart an ONU (ONT), use the following command.
Command
Mode
Description
onu reset ONU-ID
Interface
[GPON]
Resets a specified ONU.
ONU-ID: ONU ID (1 to128) or ONU serial number
•
Changing Active Firmware
If an ONU supports the dual OS, you can change the active firmware using the following
command. To change the active firmware, use the following command.
Command
Mode
Description
onu
firmware
active-change
ONU-ID
Interface
[GPON]
Changes the active OS of ONU (with ONU reboot).
ONU-ID: ONU ID (1 to 128) or ONU serial number
13.2.21.2
Manual Upgrade (2)
(1) Downloading Firmware to OLT
To download ONU (ONT) firmware in the system, use the following command.
!
