User Manual
UMN:CLI
V8102
795
To display the Point-to-Point Protocol over Ethernet (PPPoE)-related authentication in-
formation of ONU, use the following command.
Command
Mode
Description
show onu pppoe status gpon
OLT-ID ONU-ID
Enable
Global
Shows the PPPoE authentication information of ONU.
show onu pppoe account [gpon
IFPORT]
show onu pppoe status ONU-ID
Interface
[GPON]
To display information about specified port ID, use the following command.
Command
Mode
Description
show onu port-id [gpon IFPORT
]
Enable
Global
Shows information about ONU port.
To check the connection of TR069, use the following command.
Command
Mode
Description
show onu tr069 configuration
OLT-ID ONU-ID
Global
Shows the current config for TR069 of a specific ONT.
show onu tr069 status OLT-ID
ONU-ID
Shows the current connection status of a specific ONT.
show onu tr069 detail OLT-ID
ONU-ID
Shows the current detail information of a specific ONT.
13.2.23
Generic Status Portal (GSP)
The generic status portal managed entity provides a way for the OLT to discover the sta-
tus and configuration information of a non-OMCI management domain within an ONU.
The non-OMCI management domain is indicated by the virtual Ethernet interface point
associated with this generic status portal.
The generic status portal ME uses two attributes which are
status
and
config
to convey
status and configuration from a non-OMCI managed domain to the OMCI. Each of these
attributes uses an XML document to present this information.
Whenever the information in this table changes, and after a soak interval, the ONU issues
an AVC to the OLT. The rate at which AVCs are issued is controlled by the
avc-report
at-
tribute.
To configure GSP, follow these steps.
Step 1
You need to open
ONU Profile Configuration
mode to configure an ONU profile.
To create an ONU profile, use the following command.