UMN:CLI
User Manual
V8102
802
To set the threshold of ONU memory in use, use the following command.
Command
Mode
Description
memory-usage threshold
<0-
100>
ONU-Profile
Sets the threshold of ONU memory in the unit of per-
cent (%).
0-100: ONU memory in use
no memory-usage threshold
Deletes the configured threshold of ONU memory.
13.3.2.6
Uplink MAC learning
To enable/disable the MAC learning of ONT
’s internal switch, use the following command.
Command
Mode
Description
switch-control
uplink-mac-
learning enable
ONU-Profile
Enables the MAC learning of ONU
’s uplink port
switch-control
uplink-mac-
learning disable
Disables the MAC learning of ONU
’s uplink port
This feature is available for the H645B, H645, H645A only.
To display the uplink MAC learning status of ONU, use the following command.
Command
Mode
Description
show onu switch-control gpon
OLT-ID ONU-ID
Enable/Global
Shows the uplink MAC learning status of
ONU
’s uplink port.
show onu switch-control ONU-
ID
Interface [GPON]
13.3.2.7
GPON Optic Module Threshold of ONU
The ONU
’s GPON optic module can operate depending on monitoring type of tempera-
ture, RX/TX power, voltage or Txbias. To set the threshold of GPON optical transceiver of
ONU, use the following command.
Command
Mode
Description
ani-rx-power
threshold
{
low
VALUE
[
high VALUE
]
|
high VAL-
UE
[
low VALUE
] }
ONU-Profile
Configures the RX optical power threshold and sends
the configured threshold value to ONUs. The ONUs
monitors the change of values and sends RX power
high/low alarm to OLT when the RX power exceeds the
threshold or it is below the threshold.
VALUE: RX power threshold value ( -127 to 0 dBm)
ani-tx-power
threshold
{
low
VALUE
[
high VALUE
]
|
high VAL-
UE
[
low VALUE
] }
Configures the TX optical power threshold and sends
the configured threshold value to ONUs. The ONUs
monitors the change of values and sends TX power
high/low alarm to OLT when the TX power exceeds the
threshold or it is below the threshold.
VALUE: TX power threshold value ( -127 to 0 dBm)
i