User Manual
UMN:CLI
V8102
83
Command
Mode
Description
show compare-config
Enable
Shows configuration compared with startup-config and
running-config.
4.2.3
Writing System Configuration
If you change the configuration of the system, you need to save the changes in the sys-
tem flash memory. To write a current running configuration, use the following command.
Command
Mode
Description
write memory
All
Writes a current running configuration in the system
flash memory.
write terminal
Enable
Shows a current running configuration on the terminal.
(alias to the
show running-config
command)
When you use the
write memory
command, make sure there is no key input until
[OK]
message appears.
4.2.4
Auto-Saving
The V8102 supports the auto-saving feature, allowing the system to save the system con-
figuration automatically. This feature prevents the loss of unsaved system configuration
by unexpected system failure. To allow the system to save the system configuration au-
tomatically, use the following command.
Command
Mode
Description
write interval
<10-1440>
Global
Enables auto-saving with a given interval as a multiple
of 10.
10-1440: time interval (unit: minute)
no write interval
Disables auto-saving.
4.2.5
System Configuration File
To copy a system configuration file, use the following command.
Command
Mode
Description
copy running-config
{
FILENAME
|
startup-config
}
Enable
Copies a running configuration file.
FILENAME: configuration file name
startup-config: startup configuration file
copy startup-config
FILENAME
Copies a startup configuration file to a specified file
name.
copy
FILENAME
startup-config
Copies a specified configuration file to the startup con-
figuration file.
copy
FILENAME1 FILENAME2
Copies a specified configuration file to another configu-
ration file.
!