User Manual
UMN:CLI
V8102
853
To configure the maximum depth of the jitter buffer, use the following command.
Command
Mode
Description
jitter-buffer-max VALUE
VoIP-Profile
Specifies the maximum depth of the jitter buffer associ-
ated with this service.
VALUE: 0-65535, maximum depth of jitter buffer (unit:
ms)
no jitter-buffer-max
Deletes the configured maximum depth of the jitter
buffer.
To configure echo cancellation, use the following command.
Command
Mode
Description
echo-cancel
{
true
|
false
}
VoIP-Profile
Specifies whether echo cancellation is on or off. (true =
on, false = off)
To configure the variant of POTS signalling used on the associated UNIs, use the follow-
ing command.
Command
Mode
Description
pstn-protocol-variant
E164_COUNTRY_CODE
VoIP-Profile
Controls which variant of POTS signalling is used on
the associated UNIs. Its value is equal to the E.164
country code.
E164_COUNTRY_CODE: 0-65535
no pstn-protocol-variant
Deletes the configured E.164 country code.
13.7.1.4
RTP Configuration
To configure the RTP port used for voice traffic, use the following command.
Command
Mode
Description
rtp-local-port min VALUE
{
max
VALUE
}
VoIP-Profile
Defines the base and highest RTP port that should be
used for voice traffic.
VALUE: 0-65535, the base RTP port (default: 50000)
VALUE: 0-65535, the highest RTP port
To configure Diffserv code point to be used for outgoing RTP packets, use the following
command.
Command
Mode
Description
rtp-dscp-mark VALUE
VoIP-Profile
Specifies Diffserv code point to be used for outgoing
RTP packets for this profile.
VALUE: 0-255, Diffserv code point for outgoing RTP
packets
