UMN:CLI
User Manual
V8102
902
#####################################################################
#####################################################################
#####################################################################
(Omitted)
#####################################################################
#####################################################################
#####################################################################
#####################################################################
#####################################################################
####
done
Bytes transferred = 13661822 (d0767e hex)
Update flash: Are you sure (y/n)? y
Erasing
: 0x01D00000 - 0x01D1FFFF
Programming : 0x01D00000 - 0x01D1FFFF
Verifying
: 0x01D00000 - 0x01D1FFFF
Boot>
flashinfo
Flash Information(Bytes)
Area OS size Default-OS Standby-OS OS Version
-------------------------------------------------------------
os1
13661806 * *
3.01 #1032
os2
13661412
1.23 #1026
Boot>
Step 4
Reboot the system with the new system software using the following command.
Command
Mode
Description
reboot
[
os1
|
os2
]
Boot
Reboots the system with specified system software.
os1 | os2: the area where the system software is stored
If the new system software is a current standby OS, just exit the boot mode, then the in-
terrupted system boot will be continued again with the new system software.
To exit the boot mode, use the following command.
Command
Mode
Description
exit
Boot
Exits the boot mode.