User Manual
UMN:CLI
V8102
103
static
]
To remove all kernel IPv6 route caches, use the following command.
Command
Mode
Description
clear ipv6 route kernel
Enable
Removes all kernel IPv6 route caches
5.6.3.4
Enabling IPv6 Processing
To enable/disable the IPv6 processing on an interface, use the following command.
Command
Mode
Description
ipv6 enable
Interface
[MGMT/VLAN/
LO]
Enables the IPv6 processing on an interface.
no ipv6 enable
Disables the IPv6 processing on an interface.
To enable/disable global IPV6 forwarding between all interfaces, use the following com-
mand.
Command
Mode
Description
ipv6 forwarding
Global
Enables global IPv6 packet forwarding function on the
system. (Default)
no ipv6 forwarding
Disables global IPv6 packet forwarding function.
To display the status of global IPv6 forwarding, use the following command.
Command
Mode
Description
show ipv6 forwarding
Enable
Global
Shows the IPv6 status of forwarding mode.
5.6.3.5
IPv6 Interface Mode
You can configure the interface for router mode or host mode. The router mode allows the
switch to receive Router Solicitation(RS) messages or send Router Advertisement (RA)
messages to the network within this interface. In case of host mode, it functions as an
IPv6 host. The interface can not send RA messages to other devices.
To specify the IPv6 interface mode on an interface, use the following command.
Command
Mode
Description
ipv6 mode host
Interface
[MGMT/VLAN/
LO]
Configures the interface for host mode. The interface
can not send RA messages to the network.
ipv6 mode router
Configures the interface for router mode. The interface
receives RS messages and send RA messages to the
network.
