UMN:CLI
User Manual
V8102
104
no ipv6 mode
Deletes the configured IPv6 interface mode.
5.6.3.6
Displaying IPv6 interface
To display an assigned IPv6 address, use the following command.
Command
Mode
Description
show ipv6
Interface
Shows the IPv6 addresses assigned to an interface.
To display an interface status and configuration, use the following command.
Command
Mode
Description
show ipv6 interface
Enable
Global
Shows all configured interfaces and their configura-
tions.
show
ipv6
interface
{
giga-
bitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORTS
Shows the specified IPv6 interface information.
INTERFACE: IPv6 interface name
show ipv6 interface prefix
Shos the IPv6 prefix information of the specified inter-
face.
show
ipv6
interface
{
giga-
bitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORTS
prefix
show ipv6 interface vlan VLANID
prefix
show
ipv6
interface
{
giga-
bitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORTS
brief
Shows a brief summary of IPv6 interface status and
configuration.
show
ipv6
interface
brief
5.6.3.7
IPv6 PBR Configuration
To identify a route map to use for IPv6 PBR(Policy-based Routing) on an interface, use
the following command.
Command
Mode
Description
ipv6 policy route-map WORD
Interface
[XE/br/CG/GPON]
Configures a route map for IPv6 policy on the inter-
face.
WORD: route map name
To display the IPv6 policy-based routing (PBR) configuration, use the following command.
Command
Mode
Description
show ipv6 policy
Enable
Global
Shows IPv6 policy route maps attached to interface.