UMN:CLI
User Manual
V8102
106
show ip route
[
bgp
|
connected
|
kernel
|
ospf
|
rip
|
static
|
A.B.C.D
|
A.B.C.D/M
|
summary |
performance | pbr
]
Global
Shows configured routing information.
show ip route database
[
bgp
|
connected
|
kernel
|
ospf
|
rip
|
static
]
Shows configured routing information with IP routing
table database.
show
ip
route
{
A.B.C.D
|
A.B.C.D/M
}
Shows IP routing table.
A.B.C.D: network address
A.B.C.D/M: network/length eg,35.0.0.0/8
show ip route pbr
Shows policy based routing table.
show ip route performance
Shows routing performance state.
show ip route summary
Shows summary information of route.
To clear IPv4 stale kernel routes form FIB, use the following command.
Command
Mode
Description
clear ip route
[
kernel
]
Enable
Global
Clears IPv4 stale routes.
5.6.5
Displaying IP Address Assignment
To display an assigned IP address of interface, use the following command.
Command
Mode
Description
show
ip
Interface
Shows the brief information of IP address assignment.
show
ip
interface
{
brief
|
vlan
VLANS
}
Enable
Global
show ip
interface
{
gigabitether-
net
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORTS
show ip tunnel
<0-1023>
5.6.6
Initial Management Access and IP Address Assignment
You can configure the system to be accessed remotely by Telnet. Firstly, you have to in-
stall the SFU module in the central slot of the chassis. The V8102 has a management
port (MGMT) and console port on the front panel of SFU module.
After the V8102 is plugged an Ethernet cable directly from your network into the man-
agement (MGMT) port for remotely access into the switch, it is operational.
To access the system remotely via management interface, follow these steps.
1. Connect to the console port is used for direct local configuration and management.
