UMN:CLI
User Manual
V8102
116
Auto-negotiation operates only on 10/100/1000Base-T interface. You cannot enable this
function on 1000Base-X or 10GbE optical interface.
5.10.3
Transmit Rate
To set the transmit rate of a 10G Ethernet port, use the following command.
Command
Mode
Description
speed
{
10
|
100
|
1000
|
10000
}
Interface
[XE/mgmt]
Sets the transmit rate of a specified port to
10/1001000/10000 Mbps.
no speed
Deletes the configured port speed.
5.10.4
Duplex Mode
Ethernet operates in either half-duplex or full-duplex mode. In full-duplex mode, frames
travel in both directions simultaneously over two channels on the same connection for an
aggregate bandwidth of twice that of half-duplex mode. Full duplex networks are very effi-
cient since data can be sent and received simultaneously.
To set the duplex mode on an Ethernet port, use the following command.
Command
Mode
Description
duplex
{
full
|
half
}
Interface
[mgmt]
Sets full-duplex or half-duplex mode.
5.10.5
Link Monitoring Timer
The link debounce time is the amount time that an interface waits to notify the link down
state of a physical Ethernet port. When link debounce timer is enabled, port
’s link down
detection is delayed, resulting in a loss of traffic during the debounce period.
To enable/disable the debounce timer on an Ethernet port, use the following command.
Command
Mode
Description
link-debounce-time
<10-5000>
Interface
[XE/GE]
Enables the debounce timer and specify the time for an
Ethernet interface.
10-5000: timer value (in milliseconds, default: 0)
no link-debounce-time
Disables the debounce timer on the specified interface.
To display the debounce timer information, use the following command.
Command
Mode
Description
show link-debounce-time
Enable
Global
Interface
[XE/GE]
Shows the configured link debounce time value.
!