User Manual
UMN:CLI
V8102
117
To configure the interval for link monitoring on the Ethernet port, use the following com-
mand.
Command
Mode
Description
link-check-timer
<20-1000>
Interface
[XE/GE]
Specifies the time interval for checking the link of
Ethernet interface.
20-1000: interval value (in milliseconds, default:
500ms)
no link-check-timer
Disables the link checking timer on the specified inter-
face.
5.10.6
Network Service Port
To change a service port number that is in use by a different network service, use the fol-
lowing command.
Command
Mode
Description
service port
{
ftp
|
ftp-data
|
ssh
|
telnet
} <1-65535>
Global
Chages the default port number for FTP/FTP-
data/SSH/Telnet service.
1-65535: port number
(Default port number: FTP (21), FTP-data (20), SSH
(22), Telnet (23))
no service port
{
ftp
|
ftp-data
|
ssh
|
telnet
}
Deletes the configured service port number and returns
to the default port number for network service.
5.10.7
L2 Port Bridge
The L2 port bridge feature allows the port to forward the packets that the outgoing inter-
face in the MAC address entry is the same as the incoming interface where the packet ar-
rived. If one port is enabled with L2 port bridge feature, it forwards the packets to its des-
tination port when the MAC address is found in the L2 table. The switch can have multiple
MAC addresses associated with the same port.
To enable/disable the L2 port bridge feature, use the following command.
Command
Mode
Description
switchport port-bridge
Interface
[XE/GE]
Enables L2 port bridge feature on the interface.
no switchport port-bridge
Disables L2 port bridge feature. (default)
5.10.8
Port Crossover
MDI/MDIX is a type of Ethernet port connection according to the IEEE 802.3 standard us-
ing twisted pair cabling. Uplink ports on hubs and switches use the same pin assignments
that use pins 1 and 2 for transmit and 3 and 6 for receive. These ports are called Medium
Dependent Interface (MDI) ports. Normal ports use the opposite pin assignment, i.e. pins
1 and 2 are used for receive and pins 3 ans 6 are used for transmit. Such ports are called
MDIX (MDI-crossed) ports.
