UMN:CLI
User Manual
V8102
120
You can display the PID of each running processes with the
show process
command.
SWITCH#
show process
USER
PID %CPU %MEM
VSZ RSS TTY STAT START TIME COMMAND
admin
1 0.2 0.2
1448 592 ?
S
Feb23 0:05 init [3]
admin
2 0.0 0.0
0
0 ?
S
Feb23 0:00 [keventd]
admin
3 0.0 0.0
0
0 ?
SN
Feb23 0:00 [ksoftirqd_CPU0]
admin
4 0.0 0.0
0
0 ?
S
Feb23 0:00 [kswapd]
admin
5 0.0 0.0
0
0 ?
S
Feb23 0:00 [bdflush]
admin
6 0.0 0.0
0
0 ?
S
Feb23 0:00 [kupdated]
admin
7 0.0 0.0
0
0 ?
S
Feb23 0:00 [mtdblockd]
admin
8 0.0 0.0
0
0 ?
S<
Feb23 0:00 [bcmDPC]
admin
9 0.0 0.0
0
0 ?
S<
Feb23 0:29 [bcmCNTR.0]
admin
16 0.0 0.0
0
0 ?
SN
Feb23 0:00 [jffs2_gcd_mtd0]
admin
81 0.0 2.0 10524 5492 ?
S
Feb23 0:53 /usr/sbin/swchd
admin
83 0.0 1.5
6756 3756 ?
S
Feb23 0:53 /usr/sbin/nsm
(Omitted)
SWITCH#
6.1.4
FTP Bind Address
When used as an FTP client, the V8102 connects to an FTP server via the interface to-
ward that server, which means the FTP client uses the IP address configured in that inter-
face as a source IP address. However, an interface of the V8102 may have multiple IP
addresses. In such a multiple-IP environment, a primary IP address is normally used. You
can configure the V8102 to use one of the secondary IP addresses as a source IP of an
FTP client.
To use a specific IP address as a source IP of an FTP client, use the following command.
Command
Mode
Description
ftp bind-address
A.B.C.D
Global
Specifies a source IP address of an FTP client.
A.B.C.D: one of the secondary IP addresses config-
ured in an interface
no ftp bind-address
Deletes a specified source IP address.
This configuration is also applicable to a TFTP client.
6.1.5
Enable DDM Function
If you insert an SFP module including Digital Diagnostic Monitoring (DDM) function into
ports, you can monitor the operating parameters of the SFP module, including the trans-
ceiver type, length, connector type, and vendor information. However, you might not want
to see DDM polling information because it may result in CPU overload to collect DDM da-
ta via I
2
C interface. To enable or disable the DDM function of SFP mouldes, use the fol-
lowing command.
i
