UMN:CLI
User Manual
V8102
122
To delete the threshold of module operation depending on specified monitoring type, use
the following command.
Command
Mode
Description
no
threshold
module
{
rxpower
|
voltage
|
txbias
|
txpower | temper
}
{
alarm |
warning
}
Interface
[GE/XE/GPON]
Deletes the configured threshold of SFP module.
6.1.6
System Threshold
You can configure the system with various kinds of the system threshold such as CPU
load, traffic, temperature, etc. Using this threshold, the V8102 generates syslog messag-
es, sends SNMP traps, or performs a relevant procedure.
6.1.6.1
CPU Load
To set the threshold of CPU load, use the following command.
Command
Mode
Description
threshold cpu
<21-100> {
5
|
60
|
600
} [<20-100> {
5
|
60
|
600
}]
Global
Sets the threshold of CPU load in the unit of percent
(%).
21-100: CPU load high (default: 70)
20-100: CPU load low (default: 30)
5 | 60 | 600: time interval (unit: second / default:60)
threshold cpu
iu SLOT_NUM
<21-100> {
5
|
60
|
600
} [<20-100>
{
5
|
60
|
600
}]
Sets the threshold of IU’s CPU load in the unit of per-
cent (%).
21-100: CPU load high (default: 70)
20-100: CPU load low (default: 30)
5 | 60 | 600: time interval (unit: second / default:60)
no threshold cpu
Deletes the configured threshold of CPU load.
no threshold cpu iu SLOT_NUM
Deletes the configured threshold of IU’s CPU load.
To display the configured threshold of CPU load, use the following command.
Command
Mode
Description
show cpuload
Enable
Global
Shows the configured threshold and average of CPU
load.
show cpu-trueload
Shows the CPU load history during the last 10 minutes
in the time slots of every 5 seconds.
