User Manual
UMN:CLI
V8102
131
Fig. 6.2
IP Source Routing
To perform ping test as the route which the manager designated, use the following steps.
Step 1
Enable IP source-routing function from the equipment connected to PC which the PING
test is going to be performed.
To enable/disable IP source-routing in the V8102, use the following command.
Command
Mode
Description
ip icmp source-route
Global
Enable IP source-routing function.
No ip icmp source-route
Disable IP source-routing function.
Step 2
Perform the ping test from PC as the designate route with the
ping
command.
6.2.3
Tracing Packet Route
You can discover the routes that packets will actually take when traveling to their destina-
tions. To do this, the
traceroute
command sends probe datagrams and displays the
round-trip time for each node.
If the timer goes off before a response comes in, an asterisk (*) is printed on the screen.
Command
Mode
Description
traceroute
[
DESTINATION
]
Enable
Traces packet routes through the network.
WORD: destination IP address or host name
A.B.C.D: destination IP address
X:X::X:X: IPv6 address to be traced
traceroute ip
A.B.C.D
traceroute ipv6 X:X::X:X
