User Manual
UMN:CLI
V8102
149
auth
|
auth
|
priv
}
READ-VIEW
WRITE-VIEW
NOTIFY-VIEW
SNMP view record.
GROUP: group name
no snmp access
GROUP
Deletes a granted SNMP group to access a specific
SNMP view record.
To display a granted SNMP group to access to a specific SNMP view record, use the fol-
lowing command.
Command
Mode
Description
show snmp access
Enable
Global
Shows a granted SNMP group to access to a specific
SNMP view record.
7.1.9
SNMP Version 3 User
In SNMP version 3, you can register an SNMP agent as user. If you register an SNMP
version 3 user, you should configure it with the authentication key.
To create/delete an SNMP version 3 user, use the following command.
Command
Mode
Description
snmp
user
USER
{
md5
|
sha
}
AUTH_KEY
[
des
PRIVATE_KEY
]
Global
Creates an SNMP version 3 user.
no
snmp
user
USER
Deletes a registered SNMP version 3 user.
To display a current SNMP version 3 user, use the following command.
Command
Mode
Description
show snmp user
Enable
Global
Displays an SNMP version 3 user.
7.1.10
SNMP Trap
SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain
problems. If you configure the SNMP trap, the system transmits pertinent information to
network management program. In this case, trap message receivers are called a trap
host.
7.1.10.1
SNMP Trap Mode
To select the SNMP trap mode, use the following command.
Command
Mode
Description
snmp trap-mode
{
alarm-report
|
event
}
Global
Selects the SNMP trap mode.
alarm-report: alarm report based trap
event: event based trap (default)
