UMN:CLI
User Manual
V8102
160
For the V8102, the administrator can enable and disable basic TLV by selecting it. To en-
able basic TLV by selecting it, use the following command.
Command
Mode
Description
lldp
{
portdescription
|
sysname
|
sysdescription
|
syscap
}
Interface
[XE/GPON]
Selects basic TLV that to be sent in the port.
portdescription: port description
sysname: system name
sysdescription: system description
syscap: system capability
no lldp
{
portdescription
|
sys-
name
|
sysdescription
|
syscap
}
Disables basic TLV configured to be sent in the port.
To specify an IP management address to be used in the LLDP management type, length,
and TLV, use the following command.
Command
Mode
Description
lldp mgmtaddr
A.B.C.D
Interface
[XE/GPON]
Specifies an IP management address to be used in the
LLDP.
mgmtaddr: management address
no lldp mgmtaddr
A.B.C.D
Deletes the specified IP management address.
7.2.5
LLDP Message
For the V8102, it is possible to configure the interval time and times of sending LLDP
message. To configure the interval time and times of LLDP message, use the following
command.
Command
Mode
Description
lldp msg txinterval
<5-32768>
Global
Configures the interval of sending LLDP message. The
unit is second. (default: 30)
lldp msg txhold
<2-10>
Configures the periodic times of LLDP message.
(default: 4)
7.2.6
Reinitiating Delay
To configure the interval time of enabling LLDP frame after configuring LLDP operation
type, use the following command.
Command
Mode
Description
lldp reinitdelay
<1-10>
Global
Configures the interval time of enabling LLDP frame
from the time of configuring not to process LLDP
frame. (default: 2)
