UMN:CLI
User Manual
V8102
164
Before activating RMON history, check if your configuration is correct. After RMON history
is activated, you cannot change its configuration. If you need to change configuration, you
need to delete the RMON history and configure it again.
7.3.1.6
Deleting Configuration of RMON History
When you need to change a configuration of RMON history, you should delete an existing
RMON history. To delete an RMON history, use the following command.
Command
Mode
Description
no rmon-history
<1-65535>
Global
Deletes the RMON history of specified number, enter
the value for deleting.
7.3.1.7
Displaying RMON History
To display an RMON history, use the following command.
Command
Mode
Description
show
running-config
rmon-
history
All
Shows a configured RMON history.
Always the last values will be displayed but no more than the number of the granted
buckets.
The following is an example of displaying RMON history.
SWITCH(config-rmonhistory[5])#
show running-config rmon-history
!
rmon-history 5
owner test
data-source ifindex.hdlc1
interval 60
requested-buckets 25
active
!
SWITCH(config-rmonhistory[5])#
7.3.2
RMON Alarm
You need to open
RMON Alarm Configuration
mode first to configure RMON alarm.
Command
Mode
Description
rmon-alarm
<1-65535>
Global
Opens
RMON Alarm Configuration
mode.
1-65535: index number
i
i