UMN:CLI
User Manual
V8102
168
7.3.3.1
Event Community
When RMON event is happened, you need to input community to transmit SNMP trap
message to host. Community means a password to give message transmission right. To
configure community for trap message transmission, use the following command.
Command
Mode
Description
community
NAME
RMON
Configures password for trap message transmission
right.
NAME: community name
7.3.3.2
Event Description
It is possible to describe event briefly when event is happened. However, the description
will not be automatically made. Thus administrator should make the description. To speci-
fy a description about the current RMON event, use the following command.
Command
Mode
Description
description
DESCRIPTION
RMON
Specifies the description of the current RMON event.
7.3.3.3
Subject of RMON Event
You need to configure event and identify subject using various data from event. To identify
subject of RMON event, use the following command.
Command
Mode
Description
owner
NAME
RMON
Identifies subject of event. You can use maximum 126
characters and this subject should be same with the
subject of RMON event.
7.3.3.4
Event Type
When RMON event is happened, you need to configure event type to arrange where to
send event. To configure event type, use the following command.
Command
Mode
Description
type log
RMON
Configures event type as log type. Event of log type is
sent to the place where the log file is made.
type trap
Configures event type as trap type. Event of trap type
is sent to SNMP administrator and PC.
type log-and-trap
Configures event type as both log type and trap type.
type none
Configures none event type.
