UMN:CLI
User Manual
V8102
264
7.19.1.3
Sample Packet Header Size Setting
In this device, within enabled sFlow, maximum header size copied from the sample pack-
et can be set.
To set or delete the size of sFlow header, use the following command.
Command
Mode
Description
sflow max-header-size
<16-256>
Interface
[GPON]
Sets value of maximum header size in a range of <16-
256>.
no sflow max-header-size
Deletes maximum header size, and restores default
value. (default value: 128)
7.19.1.4
Counter Interval Setting
sFlow statistics feature monitors events such as analyzing characteristics of end-end unit,
adjacent network unit and collection of MIB information at the interval level. For this rea-
son, real-time packet counter interval must be set for each interface.
To set or delete counter interval of sFlow, use the following command.
Command
Mode
Description
sflow counter-interval
<1-1000>
Interface
[GPON]
Sets sflow counter interval for port in a range of <1-
1000>.
no sflow counter-interval
Deletes counter interval of port and restore default
value. (default value: 0)
Polling does not operate if counter interval value of port is in default value (0). Thus, does
not examine the status of corresponding port regularly.
7.19.1.5
Sampling Rate Setting
The number of packet extraction rate is called sample-rate. To set or delete the sampling
rate, use the following command.
Command
Mode
Description
sflow sample-rate
<0-2000>
Interface
[GPON]
Sets sample-rate of sflow in a range of <0-2000>.
no sflow sample-rate
Deletes sample-rate and restores default value. (de-
fault value: 0)
Sampling does not operate if sample-rate is in default vaule (0).
7.19.1.6
Receiver of Index Setting
User can set Receiver’s index to send sampled packet to the Collector within enabled
sflow.
i
i