UMN:CLI
User Manual
V8102
320
•
DT and HTLS cannot be configured at the same time. (If the switch should operate as
DT, HTSL has to be disabled.)
•
The TPID value of all ports on the switch is the same.
•
Access port should be configured as Untagged, and uplink port as Tagged.
•
Ignore all tag information which comes from untagged port (Access port).
•
The port with DT function can configure Jumbo function also.
9.1.5.8
Inner Tag Configuration
To attach the configured C-VLAN in the inner tag field of incoming untagged packet on a
port, use the following command.
Command
Mode
Description
vlan dot1q-tunnel ingress push
c-vid
[
VLANS
]
Interface
[XE/GE/
GPON]
Adds the configured C-VLAN tag in the inner tag field
of incoming packet on an ingress port
VLANS: 1 to 4094, VLAN ID
no vlan dot1q-tunnel ingress
push c-vid
Disables the C-VLAN inner tagging on an ingress port.
To remove the C-VLAN inner tag from the outgoing packet on a port, use the following
command.
Command
Mode
Description
vlan dot1q-tunnel egress pop c-
vid
Interface
[XE/GE/
GPON]
Removes C-VLAN tag from the outgoing packet on an
egress port
no vlan dot1q-tunnel egress pop
c-vid
Disables the C-VLAN inner tag removal on an egress
port.
9.1.5.9
Displaying VLAN Mapping
To display the configured VLAN mapping, use the following command.
Command
Mode
Description
show vlan dot1q-tunnel
{
ingress
|
egress
}
mapping all
Enable
Global
Shows the configured VALN mapping on all interfaces.
show vlan dot1q-tunnel
{
ingress
|
egress
}
mapping interface
{tengigabitethernet
|
gpon
|
channelgroup}
[
IFPORT
]
Shows the configured VLAN mapping.
show vlan dot1q-tunnel
Shows the status of UNI/NNI ports.
9.1.6
VLAN Translation
VLAN Translation is simply an action of Rule. This function is to translate the value of
specific VLAN ID which classified by Rule. The switch makes Tag adding PVID on Un-
tagged packets, and use Tagged Packet as it is. That is, all packets are tagged in the
