User Manual
UMN:CLI
V8102
327
9.2.2.4
Manual Aggregation
The port configured as member port is basically configured to aggregate to LACP. How-
ever, even though the configuration as member port is not released, they could operate
as independent port without being aggregated to LACP. These independent ports cannot
be configured as trunk port because they are independent from being aggregated to
LACP under the condition of being configured as member port.
To configure member port to aggregate to LACP, use the following command.
Command
Mode
Description
channel-group aggregation
{
ag-
gregatable
|
individual
}
Interface
[XE/GE]
Configures the property of a specified member port for
LACP. (default: aggregatable)
To clear aggregated to LACP of configured member port, use the following command.
Command
Mode
Description
no channel-group aggregation
Interface
[XE/GE]
Deletes the configured property of a specified member
port for LACP.
9.2.2.5
BPDU Transmission Rate
Member port transmits BPDU with its information. For the V8102, it is possible to config-
ure the BPDU transmission rate, use the following command.
Command
Mode
Description
channel-group timeout
{
short
|
long
}
Interface
[XE/GE]
Configures BPDU transmission rate:
short: short timeout (1 sec)
long: long timeout (30 sec: default)
To clear BPDU transmission rate, use the following command (clear means long timeout).
Command
Mode
Description
no channel-group timeout
Interface
[XE/GE]
Clears BPDU transmission rate of configured member
port, select the port number.
9.2.2.6
Administrational Key
Member port of LACP has key value. All member ports in one aggregator have same key
values. To make the aggregator consisted of specified member ports, configure the differ-
ent key value with the key value of another port.
Command
Mode
Description
channel-group admin-key
<1-
15>
Interface
[XE/GE]
Configures the key value of a member port:
PORTS: select the port number.
1-15: key value (default: 1)
