UMN:CLI
User Manual
V8102
328
To delete the key value of a specified member port, use the following command.
Command
Mode
Description
no
channel-group
admin-key
PORTS
Interface
[XE/GE]
Deletes the key value of a specified member port, se-
lect the member port number.
9.2.2.7
Port Priority
To configure priority of an LACP member port, use the following command.
Command
Mode
Description
channel-group
priority
<1-
65535>
Interface
[XE/GE]
Sets the LACP priority of a member port. (default:
32768)
To delete the configured priority of the member port, use the following command.
Command
Mode
Description
no channel-group priority
Interface
[XE/GE]
Removes the configured interface priority from this
channel-group.
9.2.2.8
Displaying LACP Configuration
To display the configured LACP, use the following command.
Command
Mode
Description
show channel-group lacp
Enable
Global
Interface
[XE/GE]
Shows the information of aggregated port.
show channel-group lacp ag-
gregator
AGGREGATIONS
Shows the information of selected aggregated port.
show channel-group lacp inter-
face all
Shows the information of member port.
show channel-group lacp inter-
face
{
gigabitethernet
|
tengiga-
bitethernet
}
IFPORT
Shows the information of appropriated member port.
show channel-group lacp statis-
tics
Shows the aggregator statistics.
To clear LACP statistics information, use the following command.
Command
Mode
Description
clear channel-group lacp statis-
tic
Enable
Global
Clears the collected statistics.
