User Manual
UMN:CLI
V8102
379
9.4.7
Configuring MSTP
To configure MSTP, use the following steps.
Step 1
Enable STP function using the
spanning-tree
command.
Step 2
Select a MSTP mode using the
spanning-tree mode
mst
command.
Step 3
Configure detail options if specific commands are required.
Step 4
Enable a MSTP daemon using the
spanning-tree mst
command.
9.4.7.1
MST Region
To set the configuration ID of MST region in detail, you need to open
MSTP Configuration
mode first. To open
MSTP Configuration
mode, use the following command.
Command
Mode
Description
spanning-tree mst configuration
Global
Opens
MSTP Configuration
mode.
After opening
MSTP Configuration
mode, the prompt changes from SWITCH(config)# to
SWITCH(config-mst)#.
To delete all configations from
MSTP Configuration
mode, use the following command.
Command
Mode
Description
no
spanning-tree
mst
configuration
Global
Deletes all configurations on
MSTP Configuration
mode, returns to the default values.
If MSTP is established in the V8102, decide a MSTP region the switch is going to belong
to by configuring the MST configuration ID. Configuration ID contains a region name, re-
vision, and a VLAN map.
To set the configuration ID, use the following command on
MSTP Configuration
mode.
Command
Mode
Description
name
NAME
MST-config
Sets the MSTP region name:
NAME: the name of MSTP region.
instance
<1-64>
vlan VLANS
Maps the specified vlans to an MSTP instance:
1-64: select an instance ID number.
VLANS: VLAN ID (1-4094)
revision
<0-65535>
Specifies a revision number:
0-65535: the MSTP configuration revision number.
