UMN:CLI
User Manual
V8102
486
lowing information:
–
Current-state
: This indicates the current filter mode including/excluding the speci-
fied multicast address.
–
Filter-mode-change
: This indicates a change from the current filter mode to the
other mode.
–
Source-list-change
: This indicates a change allowing/blocking a list of the multi-
cast sources specified in the record.
IGMPv3 Operation
Basically, IGMPv3 has the same join/leave (allow/block in the IGMPv3 terminology) and
query-response mechanism as IGMPv2
’s. Due to the major revision of the membership
report, however, leave group messages are not used for the explicit leave process any
longer. In IGMPv3 concept, membership reports with state-change records are used to al-
low or block multicast sources, and those with current-state records are used to respond
to membership queries. Membership report suppression feature has been removed for
multicast routers to keep track of membership state per host.
10.1.4
Displaying IGMP Information
To display current IGMP groups and relevant information, use the following command.
Command
Mode
Description
show ip igmp groups
[
detail
]
Enable
Global
Shows the multicast groups with receiv-
ers directly connected to the router and
learned through IGMP.
A.B.C.D: IGMP group address
IFPORT: physical interface port number
(SLOT#/PORT#, e.g. 0/1, 0/2, 1/1)
show ip igmp groups
A.B.C.D
[
detail
]
show ip igmp groups
{
gigabitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORT
[
detail
]
show ip igmp groups vlan VLAN
[
detail
]
show ip igmp groups INTERFACE
A.B.C.D
[
detail
]
show ip igmp groups
summary
show ip igmp groups
{
gigabitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORT
{
A.B.C.D
[
detail
] |
summary
}
show ip igmp interface
Shows multicast-related information on
an interface.
show ip igmp interface
{
gigabitethernet
|
tengigabitethernet
|
gpon
|
channelgroup
}
IFPORT
