UMN:CLI
User Manual
V8102
52
3.1.4
Interface Configuration Mode
The
Interface Configuration
mode configures the switch at the physical interface level. In
a particular interface mode, you can use the commands configure specific IP interface
settings, including bridge-group, description, etc.
The following table shows several types of interfaces.
Interface Type
Internal i/f Name
(Abbreviation)
Configuration (CLI)
Description
gpon
GPON
SWITCH(config)#
interface gpon
1/1
SWITCH(config-if[GPON1/1])#
G.984.x GPON
gigabitethernet
GE
SWITCH(config)#
interface gigabitether-
net
1/1
SWITCH(config-if[GE1/1])#
Gigabit Ethernet IEEE 802.3z
tengigabitethernet
XE
SWITCH(config)#
interface
tengiga-
bitethernet
0/1
SWITCH(config-if[XE1/1])#
10-Gigabit Ethernet IEEE 802.3an
management
mgmt
SWITCH(config)#
interface management
SWITCH(config-if[mgmt])#
Management interface
channelgroup
CG
SWITCH(config)#
interface channelgroup
GROUP-ID
SWITCH(config-if[CG#])#
Link aggregation
vlan
br
SWITCH(config)#
interface vlan 1
SWITCH(config-if[1])#
Virtual LAN
loopback
lo
SWITCH(config)#
interface loopback
SWITCH(config-if[lo])#
Loopback interface
tunnel
tunnel
SWITCH(config)#
interface tunnel 1
SWITCH(config-if[tunnel1])#
Tunnel interface
3.1.4.1
Ethernet Interface Mode
The Ethernet Interface mode contains commands for configuring the 1GE or 10GE inter-
face. You can open this
Interface Configuration
mode when at least one SFU_10GE4
module is installed in the V8102 chassis.
To open
Ethernet Interface Configuration
mode, enter the
interface gigabitether-
net
/
tengigabitethernet
command, then the system prompt will be changed from
SWITCH(config)# to SWITCH(config-if[GE])# or SWITCH(config-if[XE])#.
Command
Mode
Description
interface
{
gigabitethernet
|
tengigabitethernet
}
IFPORT
Global
Enters the
Interface Configuration
mode to configure
an 1G/10G Ethernet type interface.
IFPORT: physical interface port number
(SLOT#/PORT#, e.g. 0/1, 0/2)
IFPORT-RANGE: list of valid ports per Ethernet inter-
interface range
{
gigabitethernet
|
tengigabitethernet
}
IFPORT-
RANGE
