User Manual
UMN:CLI
V8102
539
To disable PIM-SM timer debugging, use the following command.
Command
Mode
Description
no debug pim sparse-mode timer
Enable
Disables PIM-SM timer debugging.
no debug pim sparse-mode timer assert
[
at
]
no debug pim sparse-mode timer
bsr
[
bst
|
crp
]
no debug pim sparse-mode timer hello
[
ht
|
nlt
|
tht
]
no debug pim sparse-mode timer joinprune
[
jt
|
et
|
ppt
|
kat
|
ot
]
no debug pim sparse-mode timer register
[
rst
]
To display the debugging information, use the following command.
Command
Mode
Description
show debugging pim sparse-
mode
Enable
Global
Shows PIM-SM debugging status.
10.3.3.7
Displaying PIM-SM Information
To display current PIM-SM information, use the following command.
Command
Mode
Description
show ip pim sparse-mode inter-
face
[
detail
]
Enable
Global
Shows PIM-SM interface information.
detail: includes VIF information
show ip pim sparse-mode local-
members
[
SHORT_IF_NAME
]
Shows PIM local membership information.
SHORT_IF_NAME: interface name
show
ip
pim
sparse-mode
mroute A.B.C.D
[
A.B.C.D detail |
detail
]
Shows the multicast routing table.
A.B.C.D: multicast group or source address
show
ip
pim
sparse-mode
neighbor
SHORT_IF_NAME
[
A.B.C.D detail | detail
]
Shows the neighbor information.
SHORT_IF_NAME: interface name
A.B.C.D: neighbor address
show
ip
pim
sparse-mode
neighbor detail
show ip pim sparse-mode pack-
et statistics
Shows the packet statistics on sparse mode.
show ip pim sparse-mode rp
mapping
Shows group-to-RP mappings.
10.3.4
Source Specific Multicast (SSM)
Multicast supports both many-to-many and one-to-many models, which are also known
as Any Source Multicast (ASM). In this model, receivers may join and leave multicast
groups with (*, G) state that indicates any source and group G. Since there is no means to
specify the source
’s information, source discovery such as the RP mechanism in PIM-SM
is needed, which is the key feature of ASM. Each group address is identified as 224.0.0.0