UMN:CLI
User Manual
V8102
56
Global Configuration
mode first!
DHCP Option 82 Configuration
mode.
Command
Description
policy
Configures the policy for option 82 field in the DHCP packet.
system-remote-id
Configures a system remote ID.
system-circuit-id
Configures a system circuit ID.
Tab. 3.6
Main Command of
DHCP Option 82 Configuration
Mode
3.1.8
Rule Configuration Mode
Rule configuration is classified by three different modes according to its roles for Rule
mechanism. You can configure a rule for incoming or outgoing packets. Using the function,
you can handle packets classified by the rule.
To open
Rule Configuration
mode, enter the
flow, policer and policy
commands, then
the system prompt will be changed from SWITCH(config)# to SWITCH(config-
flow[NAME])#, SWITCH(config-policer[NAME])# and SWITCH(config-policy[NAME])# .
Command
Mode
Description
flow
NAME
create
Global
Opens
Flow Configuration
mode.
policer
NAME
create
Opens
Policer Configuration
mode.
policy
NAME
create
Opens
Policy Configuration
mode.
Tab.3.7
shows main commands of
Rule Configuration
mode.
Command
Description
cos
Classifies an IEEE 802.1p priority.
mac
Classifies a MAC address.
action match
Configures a rule action for classified packets.
rate-limit
Comfigures a rate-limit of classified packets
priority
Configures a rule priority of specified policy.
Tab. 3.7
Main Command of
Rule Configuration
Mode
3.1.9
RMON Configuration Mode
In
RMON Configuration
mode, you can configure RMON alarm, RMON event and RMON
history. The V8102 provides three different configuration modes to configure each type of
RMON.
Command
Mode
Description
rmon-alarm
<1-65535>
Global
Opens
RMON Configuration
mode.
1-65535: index number
rmon-event
<1-65535>
rmon-history
<1-65535>
