User Manual
UMN:CLI
V8102
655
To configure a dead interval, use the following command.
Command
Mode
Description
ip ospf dead-interval
<1-65535>
Interface
[VLAN]
Configures a dead interval in the unit of second.
1-65535: interval value (default: 40)
ip ospf
A.B.C.D
dead-interval
<1-
65535>
no ip ospf dead-interval
Sets a dead interval to the default value.
no ip ospf
A.B.C.D
dead-interval
To configure a transmit delay, use the following command.
Command
Mode
Description
ip ospf transmit-delay
<1-65535>
Interface
[VLAN]
Configures a transmit delay in the unit of second.
1-65535: interval value (default: 1)
ip ospf
A.B.C.D
transmit-delay
<1-65535>
no ip ospf transmit-delay
Sets a transmit delay to the default value.
no ip ospf
A.B.C.D
transmit-
delay
12.2.4.6
OSPF Resynchronization Timeout
To set the OSPF resync-timeout interval after which adjacency is reset if out-of-band re-
synchronization has not occurred, use the following command.
Command
Mode
Description
ip
ospf
resync-timeout
<1-
65535>
Interface
[VLAN]
Configures the OSPF resync-timeout interval.
1-65535: resync-timeout interval value
ip ospf
A.B.C.D
resync-timeout
<1-65535>
no ip ospf resync-timeout
Sets the OSPF resync-timeout interval to the default
value.
no ip ospf
A.B.C.D
resync-
timeout
12.2.4.7
OSPF Maximum Transmission Unit (MTU)
Router verifies MTU when DD (Database Description) is exchanging among the routers
on OSPF networks. Basically, OSPF network can not be organized if there are different
sizes of MTUs between routers. Therefore MTU value must be consistent. Generally MTU
value is 1500 bytes on Ethernet interface.
To configure MTU on OSPF interface, use the following command.
Command
Mode
Description
ip ospf mtu
<576-65535>
Interface
[VLAN]
Configures an MTU on OSPF interface.
no ip ospf mtu
Deletes a configured MTU on OSPF interface.