User Manual
UMN:CLI
V8102
663
lator-role no-redistribution
no area
{<0-4294967295> |
A.B.C.D
}
nssa translator-role
[
de-
fault-information-originate
]
no area
{<0-4294967295> |
A.B.C.D
}
nssa translator-role de-
fault-information-originate
[
no-redistribution
] [
no-summary
]
Router
Deletes configured NSSA.
no area
{<0-4294967295> |
A.B.C.D
}
nssa translator-role no-
redistribution
[
default-information-originate
] [
no-summary
]
no area
{<0-4294967295> |
A.B.C.D
}
nssa translator-role no-
summary
[
no-redistribution
]
[
default-information-originate
]
12.2.6.5
Area Range
In case of OSPF belongs to several Areas, Area routing information can be shown in one
routing path. Like as above, various routing information of Area can be combined and
summarized to transmit to outside.
To summarize and combine the routing information, use the following command.
Command
Mode
Description
area
{<0-4294967295>
|
A.B.C.D
}
range
A.B.C.D/M
Router
Configures to use summarized infor-
mation for assigned path.
area
{<0-4294967295>
|
A.B.C.D
}
range
A.B.C.D/M
{
advertise
|
not-advertise
}
Use
advertise
option to transmit summarized routing information with using summarized
information. And use the
not-advertise
option to block the transmission of summarized
routing information to outside.
To release the configuration, use the following command.
Command
Mode
Description
no area
{<0-4294967295> |
A.B.C.D
}
range
A.B.C.D/M
Router
Releases the configuration to use
summarized information for as-
signed path
no area
{<0-4294967295> |
A.B.C.D
}
range
A.B.C.D/M
{
advertise
|
not-advertise
}
12.2.6.6
Shortcut Area
Backbone Area is the default Area among the Areas of OSPF. All traffic should pass the
Backbone Area and OSPF network must be planned for that, but there is some efficiency
way which is not to pass the Backbone Area. That is Shortcut, and it must be configured
for efficient traffic in every ABR type, see Section
To configure the shortcut option, use the following command.
Command
Mode
Description
area
{<0-4294967295> |
A.B.C.D
}
shortcut
{
default
|
disable
|
ena-
Router
Configures the shortcut option.
