User Manual
UMN:CLI
V8102
673
To make it as a default, use the following command.
Command
Mode
Description
no distance ospf
Router
Restores it as the default.
no distance
<1-255>
Deletes a configured distance of OSPF route.
12.2.15
Host Route
OSPF regards routing information of specific host as stub link information. Routing infor-
mation can be assigned to each host which is connected with one router. To configure the
routing information to each host, use the following command.
Command
Mode
Description
host
A.B.C.D
area
{
A.B.C.D
| <1-4294967295>}
Router
Configures the routing information to
each host.
host
A.B.C.D
area
{
A.B.C.D
| <1-4294967295>}
cost
<0-65535>
To delete the routing information of specific host, use the following command.
Command
Mode
Description
no host
A.B.C.D
area
{
A.B.C.D
| <1-
4294967295>}
Router
Deletes the routing information to each
host.
no host
A.B.C.D
area
{
A.B.C.D
| <1-
4294967295>}
cost
<0-65535>
12.2.16
Passive Interface
The passive interface which is configured by OSPF network operate as stub area. There-
fore passive interface can not exchange the OSPF routing information.
To configure the passive interface, use the following command.
Command
Mode
Description
passive-interface
all
Router
Configures the passive interface.
VALNID: vlan ID
A.B.C.D: interface address.
passive-interface
vlan VLANID
[A.B.C.D]
To release the configured as passive interface, use the following command.
Command
Mode
Description
no passive-interface
INTERFACE
[
A.B.C.D
]
Router
Releases the configured as passive interface.
