User Manual
UMN:CLI
V8102
699
4294967295 |
A.B.C.D
}
WORD: OSPFv3 process tag
To display the routing information which is registered in routing table, use the following
command.
Command
Mode
Description
show ipv6 ospf
[
WORD
]
route
Enable
Global
Shows the routing information which is registered in
routing table.
To configure the format of displaying OSPFv3 routing table, use the following command.
Command
Mode
Description
ipv6 ospf display route single-
line
Global
Configures the format of displaying entries in OSPFv3
routing table in single line.
no ipv6 ospf display route sin-
gle-line
Deletes a configured format of displaying OSPFv3
routing table.
To display the information of virtual link, use the following command.
Command
Mode
Description
show ipv6 ospf
[
WORD
]
virtual-links
Enable
Global
Shows the information of virtual link.
12.3.15.2
Logging Neighbor Changes
To enable/disable the system to log changes in OSFPv3 neighbors
’ state such as system
up/down and reset, use the following command.
Command
Mode
Description
ospf log-neighbor-changes
Router
Enables logging of OSPFv3 neighbor state changes
no ospf log-neighbor-changes
Disables logging of OSPFv3 neighbor state changes
12.3.15.3
Limiting Number of Database
The V8102 can limit the Number of Database to process in OSPF. For example, if a rout-
er connected with many of routers, it carries overload to process the database. Therefore,
Limiting the Number of Database reduces the overload on system.
To configure the limiting Number of Database, use the following command.
Command
Mode
Description
max-concurrent-dd
<1-65535>
Router
Configures the limiting number of database.
no max-concurrent-dd
Deletes the configured number of database.
