User Manual
UMN:CLI
V8102
773
13.2.11.2
ANI RF Video Port Configuration
To configure the ANI RF video port of ONU, use the following command.
Command
Mode
Description
onu port-config ONU-IDs ani
video
ANI-PORTs
agc
AGC_VALUE
Interface
[GPON]
Configures the AGC value of ONU ANI RF video port.
ONU-ID: 1-128 or ONU serial number
ANI-PORT: ANI port number
AGC_VALUE: Automatic Gain Control value (-
12.7~12.7 dB)
no onu port-config ONU-IDs ani
video ANI-PORTs agc
Deletes the AGC value of the specified ONU ANI video
port.
13.2.11.3
Displaying Multicast Counter Information
To display the multicast counter information per UNI Ethernet port of ONU, use the follow-
ing command.
Command
Mode
Description
show onu igmp-pm-data gpon
OLT-ID ONU-ID uni
{
eth
|
virtual-
eth
}
UNI-PORT
Enable
Global
Shows the IGMP message counters per UNI port of
ONU. The counters are a total number of success-
ful/unsuccessful joins, leave messages, general que-
ries, specific queries and invalid IGMP messages.
ONU-ID: 1-128 or ONU serial number
UNI-PORT: UNI port number
show onu igmp-pm-data ONU-ID
uni
{
eth
|
virtual-eth
}
UNI-PORT
Interface
[GPON]
clear onu igmp-pm-data ONU-ID
uni
{
eth
|
virtual-eth
}
UNI-PORT
Clears the collected IGMP message counters.
13.2.11.4
PPPoE Configuration
To configure the Point - to -Point Protocol over Ethernet (PPPoE) of ONU, use the follow-
ing command.
Command
Mode
Description
onu
pppoe
ONU_ID
host
HOST_NUM user-account USER
PASSWORD
Interface
[GPON]
Configures the PPPoE of ONU and sets the user and
password for PPPoE configuration server.
ONU-ID: 1 - 128 or ONU serial number
HOST_NUM:
host number
USER :
user name used for authentication
PASSWORD:
password used for authentication
no onu pppoe ONU_ID host
HOST_NUM
Deletes the configured PPPoE host number.
show
onu
pppoe
account
[ONU_ID]
Shows the PPPoE account of ONU.
show onu pppoe status ONU_ID
Shows the ONU status information for PPPoE.
