UMN:CLI
User Manual
V8102
816
multicast link-mac-bridge ena-
ble
Traffic-
Bridge
Connects the multicast GEM port network CTP ME to a
MAC bridge service profile ME. (default)
multicast link-mac-bridge disa-
ble
Disables the connections between the multicast GEM
port network CTP ME to the MAC bridge service pro-
file.
13.4.3.5
ANI Port Configuration
To enable/disable a connection between MAC bridge service profile and a mapper ID, use
the following command.
Command
Mode
Description
ani mapper MAPPER_ID
Traffic-
Bridge
Connects a MAC bridge service profile with a mapper
ID.
MAPPER_ID: IEEE802.1p mapper ID (1 to 32)
no ani mapper MAPPER_ID
Disconnects a mapper ID from the MAC bridge service
profile.
To enable/disable a connection between MAC bridge service profile and the GEM Port ID
Network TCP, use the following command.
Command
Mode
Description
ani gem GEM_NUM
Traffic-
Bridge
Connects a MAC bridge service profile with a GEM
Port ID.
GEM_NUM: GEM port ID (1 to 32)
no ani gem GEM_NUM
Disconnects a GEM Port ID from the MAC bridge ser-
vice profile.
If there are more than one mapper connected to a MAC bridge service profile, you need
to configure a VLAN tagging filtering for VLAN ID-based traffic forwarding. To ena-
ble/disable VLAN tagging filtering function on ANI interface, use the following command.
Command
Mode
Description
vlan-filter
[
vid
<1-4094>]
un-
tagged
{
allow
|
discard
}
Traffic
Bridge-ANI
Enables a VLAN tagging filtering function of ANI-side
port.
allow: forwards the untagged frames to the ANI-side
port
discard: blocks the untagged frames to the ANI-side
port
1-4094: VLAN ID(s)
vlan-filter vid
{
add
|
del
}
VID
Adds or deletes the VLAN ID on the VLAN list config-
ured by
vlan-filter vid
command above.
no vlan-filter
Disables the VLAN tagging filtering function.
The V8102 provides an alternate approach to address filtering from that supported
through MAC bridge port filter table data. This alternate approach is useful when all