UMN:CLI
User Manual
V8102
824
13.4.4.4
Displaying T-CONT Information
To display the information of T-CONT, use the following command.
Command
Mode
Description
show
tcont-id
gpon
OLT-ID
[
ONU-ID
]
Enable
Global
Shows the information of T-CONT ID of OLT.
show onu tcont gpon OLT-ID
show tcont
[
ONU-ID
]
Interface
[GPON]
Shows the information of T-CONT allocation for ONU.
show onu detail-info
[
ONU-ID
]
Shows the detailed information (status, serial number,
T-CONT number, T-CONT queue number) of ONU.
show current-profile
All modes
of Traffic-
profile
Shows the information currently configured for the pro-
file.
13.4.5
IP Host Service Configuration
In order to configure an IP host, you need to create an IP host service ID. To create the IP
host service ID and enter the configuration mode for the host, use the following command.
Command
Mode
Description
ip-host-config HOST_NUMBER
Traffic-
Profile
Creates the IP host service ID and enters the
configuration mode for the host.
HOST_NUMBER : IP host number (1-32)
no ip-host-config HOST_NUMBER
Deletes the created IP host service ID.
After opening
IP-host Configuration
mode, the prompt changes from SWITCH(config-
traffic-pf[
NAME
])# to SWITCH(config-traffic-pf[
NAME
]-iphost[
ID
])#.
13.4.5.1
IP Address
To specify the IP address assignment on the host, use the following command.
Command
Mode
Description
ip address
{
static
|
dhcp
}
Traffic-
IP-host
Specifies the IP address assignment on the host.
13.4.5.2
DNS
To specify the DNS address assignment on the host, use the following command.
Command
Mode
Description
dns primary A.B.C.D
[
secondary
A.B.C.D
]
Traffic-
IP-host
Specifies the primary/secondary DNS IP address on
the host.