UMN:CLI
User Manual
V8102
826
13.4.5.5
IPv6 DHCP Client Configuration
To configure the IPv6 DHCP client mode, use the following command.
Command
Mode
Description
ipv6 dhcp client na
Traffic-
IP-host
Sets the DHCPv6 client mode using non-temporary
address.
ipv6 dhcp client stateless
Sets the DHCPv6 client mode using the stateless ad-
dress.
To configure the DHCPv6 client information, use the following command.
Command
Mode
Description
ipv6 dhcp client information
refresh
minimum
<600-
315360000>
Interface
[br/lo]
Sets the DHCPv6 client mode using non-temporary
address.
minimum: minimum time
600-315360000: information refresh time (unit: second,
default: 86400
ipv6
dhcp
client
pd
PRE-
FIX_NAME [rapid-commit]
Sets the DHCPv6 client mode using the prefix delega-
tion.
PREFIX_NAME: ipv6 address prefix name
hint: requests specified prefix
ipv6
dhcp
client
pd
hint
X:X::X:X/M
ipv6 dhcp client statelessconfig
Sets the DHCPv6 client mode using the stateless auto-
configuration.
To control transmission of IPv6 Router Solicitation(RS) messages on the host, use the fol-
lowing command.
Command
Mode
Description
ipv6 suppress-rs
Traffic-
IP-host
Disables the sending of RS messages on the IP host.
no ipv6 suppress-rs
Sends RS messages on the IP host.
To clear the IPv6 DHCP client, use the following command.
Command
Mode
Description
clear ipv6 dhcp client
{
tengiga-
bitethernet
IFPORT
|
gpon
IFPORT
|
channelgroup IFPORT
| vlan VLANID
}
Global
Clears the ipv6 dhcp client on the port.
13.4.5.6
Extended VLAN Tagging Operation Profile Association
To associate the extended VLAN tagging operation profile to the host, use the following
command.
Command
Mode
Description
