User Manual
UMN:CLI
V8102
831
To specify POTS holdover time, use the following command.
Command
Mode
Description
pots-holdover-time
<0-65535>
Traffic
VoIP-UNI
Determines the time during which POTS loop voltage is
held up when the ONT is not ranged on the PON. After
the specified time elapses, the ONT drops loop voltage,
and may thereby cause premises intrusion alarm cir-
cuits to go active. When the ONT ranges successfully
on the PON, it restores POTS loop voltage immediately
and resets the timer to zero.
0-65535: POTS holdover time (unit: second, default:
0(= ONT vendor's factory policy))
13.4.6.5
Protocol Type Configuration
To perform the configuration for protocol type-based service that is offered from an IP
host, use the following command.
Command
Mode
Description
udp port PORT tos TOS
Traffic-VoIP
Specifies
the
port
number
that
offers
the
UDP/TCP/TLSP/protocol-type service and the value of
the TOS field of the IPv4 header.
PORT: port number
TOS: type of service per IETF RFC 1349 or a differen-
tiated services code point (DSCP) defined by IANA
(default: 0)
protocol
{
udp
|
tcp
|
tlsp
|
TYPE
}
port PORT tos TOS
13.4.7
TDM Service Configuration (CES UNI)
This section describes the configuration of CES UNI in the ONT where the physical path
terminates and physical level functions are performed.
In order to configure CES UNI and TDM service, you need to specify the CES port first.
To specify the CES port, use the following command.
Command
Mode
Description
ces PORT
Traffic-
Profile
Specifies the CES port.
PORT: CES port number (1 to 8)
no ces PORT
Deletes the CES port configuration.
After opening
CES Configuration
mode, the prompt changes from SWITCH(config-traffic-
pf[
NAME
])# to SWITCH(config-traffic-pf[
NAME
]-ces[
PORT
])#.
