User Manual
UMN:CLI
V8102
843
ered as a last resort for frames that do not match any other applicable rule. Best practice
dictates that these entries not be deleted; however, they can be modified to produce the
desired default behaviour.
15, x, x, 15, x, x, x, (0, 15, x, x, 15, x, x)
15, x, x, 14, x, x, x, (0, 15, x, x, 15, x, x)
14, x, x, 14, x, x, x, (0, 15, x, x, 15, x, x)
The
‘x’ is a "do not care" field and should be set to zero.
Fig. 12.7
Received Frame Layout
13.6.1.1
Configuration for Single-tagged Frame Treatment
To create the mapping table to configure the single-tagged frame treatment, use the fol-
lowing command.
Command
Mode
Description
single-tagged-frame TABLE
GPON-ext-
vlan-oper
Creates the mapping table to configure the single-
tagged frame treatment.
TABLE: table number
no single-tagged-frame TABLE
Deletes the specified table.
After opening (creating) the mapping table to configure the single-tagged frame treatment,
the prompt changes from SWITCH(config-ext-vlan-oper[
NAME
])# to SWITCH(config-ext-
vlan-oper[
NAME
]-single-tagged-frame[
TABLE
])#.
