33
Instructions for Use
Giving Voice Commands
1
2
Time to hear a voice command
•
In autonomous mode, right after the Genibo stop acting and display question
marks (??) on its eyes with 'dang' sound.
•
Right after question marks (??) are displayed on the Genibo’s eyes and ‘dang’
sound occurs after touching the head touch sensor for over 3 seconds.
•
Right after question marks (??) are displayed on the Genibo’s eyes and ‘dang’
sound occurs after pressing ‘1’ and ‘OK’ on the remote control.
How to recognize your voice commands well
•
Microphone is on the Genibo’s left shoulder. The Genibo can listen well when
hearing within distance of 50cm~1m.
•
Voice commands must be given louder than the surrounding noise – but not too
loud – and clearly.
•
The Genibo can hear sound made within 1~6 seconds after question marks are
displayed on the eye emoticon LED and ‘dang’ sound occur. Speak 1 second
after the dang sound.
•
The Genibo cannot understand if a command is uttered more than twice. Say it
only once.
•
Once a command is given, do NOT make any other noise until the Genibo moves.
•
Once it understands a command, the Genibo will make ‘ding dong dang’ sound
and follow the command.
•
Voice will not be recognized while the robot is moving or is not ready to listen.
•
Any noise coming from TV or radio can be very loud for the Genibo. Speak a
command in a quiet place without TV or radio around. The Genibo will understand
better.
•
Use voice commands on ‘Voice Command List’ in this manual only.
•
The Genibo may not act on a command if in a bad mood or having low
intelligence. Love your the Genibo a lot all the time.